Houston Garage Door Repair Call (832) 924-6906

Opener repair

Garage door opener repair in Houston, TX

An automatic opener that hums, clicks, reverses for no reason or does nothing at all usually has one of a short list of problems. Most of them are repairable without replacing the whole unit.

Call (832) 924-6906 or send the details for a free estimate

Ceiling-mounted garage door opener motor with its light cover lit
A ceiling-mounted opener. The rail, trolley and gear inside do most of the wearing.

What we look at first

  • Safety sensors. If the door starts down and reverses, or the opener light blinks, the photo-eyes near the floor are often out of line or dirty. In Houston, a sensor bracket bumped by a trash can or lawn mower is a common cause.
  • Drive gear. The motor runs, the light comes on, but the chain or belt doesn't move: the plastic drive gear has stripped.
  • Logic board and wiring. Nothing happens at all, or the opener acts on its own after a storm or power surge.
  • Remotes and keypads. Dead batteries, lost programming, or a lock mode left on at the wall button.
  • The door itself. An opener that struggles may be pulling against a broken spring or a binding track. We check the door before blaming the motor.

Repair or replace?

If the motor is sound and parts are available, we repair it. If the opener is old enough that parts are hard to find, or it lacks the photo-eye safety system required on openers built in the last few decades, we'll tell you that replacement makes more sense and why. Either way you get the options in plain terms and you decide.

Garage door opener motor mounted to the ceiling with its rail running toward the door
Opener head and rail. If the trolley won't move, the drive gear is a common culprit.

Chain, belt and screw drives

We work on all three. Chain drives are the workhorse, loud but tough. Belt drives are quieter, a good fit for a garage under a bedroom. Screw drives have fewer parts but don't love temperature swings. Wall-mount (jackshaft) openers are also on the list.

Power outages and the emergency release

When the power goes out, the red cord hanging from the opener trolley disconnects the door so you can lift it by hand. That only works safely if the springs are good. After an outage, pull the door down, then run the opener once to re-engage the trolley. If you'd like the door to work during outages, ask about openers with battery backup.

Common questions

Why does my garage door reverse before it closes?

Usually the safety sensors. Check that nothing is blocking them and that both small lights are steady, not blinking. If that doesn't fix it, the force or travel limits may need adjusting, or something on the door is binding.

My opener hums but the door doesn't move. What is that?

Often a stripped drive gear, a disconnected trolley, or a door that is too heavy because a spring broke. Don't keep pressing the button; that can burn out the motor.

Can you program new remotes and keypads?

Yes, along with car-built-in buttons where the opener supports them.

Do you repair automatic openers for commercial doors?

Yes. See our commercial garage door repair page for trolley and jackshaft operators on overhead doors.

Door stuck? Start with a call.

Tell us what the door is doing and roughly where in Houston you are. If you would rather type it out, the estimate form goes to the same people.

Call (832) 924-6906 Free estimate form

Call (832) 924-6906 Free estimate